User's Manual

MAINTAINING THE BOLT
1. De-gas the marker and insure that there are no paintballs in
the breech or barrel of the marker.
2. Remove the bolt from the marker by pulling upward on the
pull pin.
3. Slide the bolt to the rear of the marker body.
4. Inspect the surface of the bolt and o-rings for excessive
wear or nicks, and replace as necessary.
5. Place one drop of oil on each o-ring and spread it around
the ring with your finger to ensure an equal coating.
6. Inspect the firing chamber and body – if necessary run a
c l ea n swab through the body to clean out any dust or debris.
7. Reinsert the bolt into the marker ensuring to place the pin into the groove of the ram.
MAINTAINING THE RAM
1. Remove the bolt from the marker
2. Remove the back cap from the marker
3. Tap the ram out into the palm of your hand – if you have
trouble tapping it out use a hex key or chopstick to push it
back from the top where the bolt sits.
4. Wipe off any old grease or debris.
5. Wipe out any old grease from the ram housing using a
swab.
6. Inspect the o-rings for excessive wear or nicks, and replace
as necessar y.
7. Apply a thin coat of grease to the o-rings.
8. Reinsert the ram with the smaller diameter section to the
f r on t o f th e m ar k e r.
9. Replace the back cap and tighten snugly.
10. Perform the Bolt maintenance process.