User's Manual
15 16
ASSEMBLY & DISASSEMBLY
INTIMIDATOR
GEN4
IIII.. RREEGGUULLAATTOORR DDIISSAASSSSEEMMBBLLYY
(continued)
TORPEDO/HIGH PRESSURE REGULATOR( LPR)
1. Unscrew Allen Adjuster.
2. Unscrew Lower End of
(
HPR
)
High-Pressure Regulator Housing.
3. Remove Regulator Spring Washer.
4. Remove Regulator Spring.
5. Remove Piston.
NOTE
:
At this time the Regulators are disassembled. Listed below are key elements to remember during assembly.
1. Piston: Ensure cupped end of Piston is facing towards Pin Valve.
2. Pin Valve: Ensure Pin Valve is not bent and seats in cupped end of Piston.
Failure to do so will cause Regulators to function improperly.
3. Air Barb: Ensure fiber washer is on Air Barb base when installing.
This will ensure Air Barb does not leak.
4. Poppet Spring Attachment: Ensure small end of Spring sits firmly on Poppet.
5. ASA Block: Place small portion of Loctite on Retaining Allen when installing.
This will ensure ASA (regulator) Base does not work itself loose during operation.
6. Remove Pin Valve Retainer.
7. Remove Teflon Washer.
8. Remove Pin Valve.
9. Remove Spring from Upper Reg. Housing.
10. Upper End of
(
HPR
)
High-Pressure
Regulator Housing.
Remove ASA Block From Body
Remove LPR Retaining Allen
Remove Air Barb From ASA Block
1
2
Low-Pressure Regulator
3
ASSEMBLY & DISASSEMBLY
IIII.. RREEGGUULLAATTOORR DDIISSAASSSSEEMMBBLLYY
ASA BLOCK/HOUSING
FIRST
:
Remove Both Regulators & Front Hose.
1.
Remove Air Barb from Regulator Base
(
ASA Block.*
)
2. Remove Regulator Base Retaining Screw
from Body.
3. Slide Regulator Base from Body.
*
Use great caution when Removing or Reinstalling Air Barbs
as they are somewhat delicate. Air Barb on front Block must
be removed in order to gain proper access to Regulator Base
Retaining Screw. Failure to do so may result in damage to the
Air Barb.
LOW PRESSURE REGULATOR( LPR)
1. Unscrew Allen Adjuster.
2. Unscrew Adjustment End
(
Part 2
)
from ASA
End
(
Part 10
)
of Low-Pressure Regulator.
3. Remove Regulator Spring Washer.
4. Remove Regulator Spring.
5. Remove Piston.
6. Remove Pin Valve Retainer.
7. Remove Teflon Washer.
8. Remove Pin Valve.
9. Remove Spring from Upper Regulator Housing.
10. ASA End of
(
LPR
)
Low-Pressure
Regulator Housing.
3
5
4 86 7
9
101
2
Low-Pressure Regulator
3
5
4 86 7
9
101
2