User's Manual

11 12
BOARD OPERATION
INTIMIDATOR
GEN4
COMPETITION LOCK
ACTIVATING COMPETITION LOCK
1. Turn Marker OFF.
2. Open up Trigger Frame to gain access to the Circuit Board.
3. Short out C and D Terminals
(
holes
)
of the top of the board.
Paper clips work well for this. Bend the clip so that one
end is touching the D and the other end is touching C.
4a. Turn Marker ON.
4b. The display window will show “Comp On” then in the
normal window the display will show
[
C
]
.
(
see figure 8
)
5. Turn Marker OFF.
6. Disconnect the D and C short and leave off
for at least 30 seconds.
7. Reassemble Trigger Frame.
8. Ready to use with COMPETITION LOCK.
To turn OFF Competition Lock follow the same procedure.
When not activated the display will not show
[
C
]
on the LCD.
For information and instructions regarding previous and/or
future versions of the FRENZY Board
(
Other than version 116.2
)
,
please refer to separate instructions sheet included in box.
Follow all the steps to set Mode to COMPETITION LOCK
Short out C and D Terminals
Open Trigger FrameTurn Marker OFF
12
3
Short out C and D Terminals
6
Turn Marker OFF
54B4a
Turn ON Comp Lock ON
7
Reassemble Trigger Frame
8
COMPETITION LOCK Active