User's Manual

17 18
ASSEMBLY & DISASSEMBLY
INTIMIDATOR
GEN4
Remove Eyes Lift Bolt Pin & Remove Bolt Remove Ram Cap
Remove Center Hose Remove Rear Hose Remove Eye Covers
ASSEMBLY & DISASSEMBLY
IIIIII.. BBOODDYY DDIISSAASSSSEEMMBBLLYY
FIRST
:
Ensure Barrel is removed from Marker Body.
1. Remove Center Hose.
2. Remove Rear Hose.
3. Remove both Eye Sensor Covers
(
one on each side
)
by removing Retaining Screw.
4. Remove both Eye Sensors
(
one on each side
)
by carefully pulling sensor heads from mounting holes.
5. Lift up on Bolt Retaining Pin and slide Bolt out of rear of Marker.
6. Remove Ram Sleeve Cap located at the rear of Marker.
(
turn counter-clockwise
)
.
7. Turn Marker up and allow ram to slide out of Marker rear. Place hand underneath to catch ram.
Do not allow ram to fall freely onto ground or any other hard surface.
8. Turn Body over to gain access to the bottom of the Marker Body.
123
45 6
Remove Center Barb Remove Rear Air Barb Block
IIIIII.. BBOODDYY DDIISSAASSSSEEMMBBLLYY
(continued)
9. Remove Air Barb from Center of Ram Sleeve.
Do not lose fiber washer at base of Air Barb.
10. Remove Air Barb Block from Rear of Body.
Separate carefully so as not to lose the O-ring.
11. Remove Ram Sleeve retaining allen.
12. Remove the Ram Sleeve from the body. During removal, rotate
the Ram Sleeve right and left while pulling towards the rear of
the Marker carefully so as to avoid cutting the O-ring.
13. Loosen Valve from Ram Sleeve using a 3/8” Socket.
14. Remove Valve from Ram Sleeve.
15. Remove Poppet from Ram Sleeve.
16. Remove Feednack Collar.
17. Remove feedneck Base.
9
Remove FeedneckBase
17
Remove Poppet
15
Loosen Valve Using 3/8” Socket
13
Remove Ram Sleeve Retaining Allen
11
NOTE
:
At this time the Body
is disassembled. Listed on the
following page are key points
to remember during assembly.
Remove Feedneck Collar
16
Remove Valve
14
Remove Ram Sleeve
12
10
Remove Ram Turn Body Over
78