User's Manual
B
B
o
o
b
b
L
L
o
o
n
n
g
g
i
i
n
n
t
t
i
i
m
m
i
i
d
d
a
a
t
t
o
o
r
r
B
B
o
o
b
b
L
L
o
o
n
n
g
g
i
i
n
n
t
t
i
i
m
m
i
i
d
d
a
a
t
t
o
o
r
r
Assembly and Disassembly
Getting Started
WHEN DISASSEMBLING THE INTIMIDATOR ALWAYS ENSURE THE MARKER IS DEGASSED.
The DISASSEMBLY portion of this manual will be divided into three sections.
I. Trigger Disassembly
II. Regulator Disassembly
III. Body Disassembly
NOTE: When ASSEMBLING the Intimidator, perform the entire disassembly
process in reverse order.
I. TRIGGER DISASSEMBLY
1. Remove 2 Trigger Assembly retaining screws. Ensure both washers are installed during assembly.
2. Separate Trigger Assembly from Main Body to expose airlines.
3. Disconnect both Eye Sensor Harnesses.
4. Disconnect all 3 Airlines (Hoses) from body.
NOTE: Use care when removing airlines.
Always inspect hoses after removal to ensure no tears or damage occurred during removal.
5. Remove left side LCD Grip.
6. Remove 4 allens to separate Trigger Frame Halves.
11
Assembly and Disassembly
TRIGGER DISASSEMBLY
(
continued
)
7. Remove 2 Board retaining screws.
(
1 1/16 Allen Head screw and 1 Phillips Head screw
)
8. Flip Board over towards left side.
9. Lift up on black LCD ribbon locks located on each side of membrane ribbon harness and
remove complete membrane assembly from trigger frame.
10. Remove Eye Sensor Wire Harness.
11. Remove Battery and Solenoid Harness.
12. Remove Circuit Board.
13. Remove Solenoid.
14. Remove 2 Trigger Guard Screws to remove Guard.
15. Remove Shoulder
ed Trigger Retaining Screw and lift out Trigger and Trigger Return Spring.
2005
12
Disconnect Hoses Grip Removal Separate Trigger Halves
Trigger Assembly Screws Separate Frame From Body Disconnect Eye Harnesses
WARNING!
Ensure Air Source is disconnected and Marker
is discharged before making any mechanical
adjustments to Marker internals or electronics.
Remove Solenoid Trigger Guard Removal Remove Trigger Screw
Remove Eye Wire Harness Remove Noid & Batt. Harness Remove Circuit Board
Lift up LCD Ribbon LocksFlip Board to Expose Wiring
Remove Board Retaining Screws
123
6
4
5
789
10 11 12
13 14 15