User's Manual

Intimidator-21
TROUBLESHOOTING
Refer to Assembly/Disassembly to perform repairs indicated below.
Problem Cause Repair
When gas is applied to the
gun a load POP is heard
and air is escaping in our
around the Trigger Frame.
Airline or lines have
become stretched or
disconnected from Ram
Sleeve (usually due to over-
pressurizing of the
Regulators).
Re-connect airline.
Replace stretched/leaking
airline.
The Low pressure
Regulator is over-
pressurized and causing
the Air Valve to leak.
Turn down Low Pressure
Regulator.
Foreign Material has lodged
inside Air Valve.
It is not recommended to
disassemble the Air Valve.
Remove and return Air
Valve to factory.
Gun leaks from inside the
Trigger Frame and hoses
are fine.
Heavy use of lightweight oil
ion marker causing internal
destruction of Air Valve.
It is not recommended to
disassemble the Air Valve.
Remove and return Air
Valve to factory.
Gun consistently leaks
down the barrel, decreasing
slightly when bolt is pushed
forward.
Heavy use of lightweight oil
causes deterioration of
Poppet O-ring and/or Cup
Seal.
Remove Poppet and
replace O-ring. Remove
and replace Cup Seal.
If bolt moves freely, one or
more of the airlines are
crimped.
Remove grip and re-
position airline/lines
Gun is pressurized and will
not fire.
If bolt does not move,
Trigger Solenoid is sticking
or inoperable. The solenoid
flap wedging against the
Trigger Spring housing
causes this.
Remove Grip and re-
position Trigger Solenoid.
LCD shows nothing or
displays unreadable
characters.
Ribbon has become
disconnected or damaged.
Re-connect ribbon to
docking port on circuit
board. If ribbon is
damaged remove and
return to factory.