User's Manual

Intimidator-18
Body Disassembly
1. Remove barrel from marker.
2. Remove Eye Sensor covers (both sides) by
removing retaining screw (1 each side).
3. Remove Eye Sensor Harness (both Sides) by
carefully pulling sensor heads from mounting
holes. Be careful not to loose small o-ring on
each head.
4. Lift up on bolt-retaining pin and slide bolt out of
rear of marker.
5. Remove rear sleeve cap screw.
6. Remove decorative cover.
7. Turn marker up and allow ram to fallout of marker
rear. Hold hand underneath to catch ram. Do
not let ram fall freely on to ground or any other
hard surface.
8. Remove poppet from sleeve front. Use a small
pair of pliers to grab poppet end. Do not use
force on poppet. Poppet will come out with little
or no pulling pressure. Use care not to damage
poppet lip. Damaging poppet lip will not allow the
poppet to seal properly to the cup seal.
9. Remove cup seal. Use extreme caution not to
scratch or damage cup seal. It is recommended
to replace the cup seal every time it is removed.
Any small scratch or fragment on the cup seal will
induce an air leak.
10. Turn body over to gain access to the bottom of
the marker.
11. Remove air barb from middle of sleeve. Do not
loose fiber washer at base of air barb.
12. Remove sleeve retaining allen.
13. At this time you are ready to remove the sleeve
from the body. When removing rotate the sleeve
right and left pulling towards the rear of the
marker. Use caution to avoid cutting the o-rings.
There are sharp openings that the o-rings must
cross.
Note: At this time the Body is disassembled.
Listed below are key points to remember when
assembly occurs.
q O-rings: Apply grease to all o-rings before
installing.
q Front Sleeve O-ring: To ensure a good seal take
a piece of Teflon tape and wrap around groove in
sleeve. Ensure all Teflon tape is in groove.
Place o-ring over the top of the Teflon tape.