User's Manual

Intimidator-15
19. Turn trigger frame over and remove LCD screen
retaining screws (4 each). Leave screws in LCD
holes.
20. Remove LCD screen from trigger frame top. Use
caution when removing not to loose screws.
21. Remove trigger spring housing retaining screw (1
each). Use caution as housing and spring will fall
after screw has been removed.
Note: At this time the Trigger is disassembled.
Listed below are key points to remember when
assembly occurs.
q LCD Install: Ribbon comes pre-folded from the
factory. Fold ribbon and place screws in LCD
before placing into trigger frame. Feed LCD
through top of trigger frame. Start all screws in al
holes prior to tightening.
q Trigger Micro-switch: When installing Trigger
Micro-switch, start screws, push solenoid towards
base of trigger frame and tighten screws. This
ensures the Micro-switch flap does not bind
against the trigger spring housing.
q Circuit Board: Do not over tighten the circuit
board. Lay harness in trigger frame to avoid
pinching of wires when attaching grips.
q Harness Connection: When connecting to the
circuit board ensure orange wire is up on 12 point
harness and black and red wire is up on 14 point
harness.