User's Manual

Intimidator-14
DISASSEMBLY/ASSEMBLY
When disassembling the Intimidator always ensure the marker is de-gassed. The
disassembly portion of this manual will be divided into three sections.
q Trigger disassembly
q Regulator disassembly
q Body disassembly
When assembling the marker perform the respective assembly on reverse order as
disassembly.
Trigger Disassembly
1. Remove both side grips.
2. Disconnect battery.
3. Disconnect Grip membrane from wire harness.
4. Lift up on LCD white ribbon locks located on
Circuit Board.
5. Remove ribbon from Circuit Board.
6. Remove Circuit Board retaining screw.
7. Disconnect wire harnesses from backside of
Circuit Board.
8. Remove Circuit Board, and place in safe area.
Note: Removing Circuit Board before
disconnecting Trigger Assembly from body will
reduce the risk of damaging the board during
disassembly.
9. Remove Trigger Assembly retaining screws (2
each). Ensure longer screw goes in back when
assembling.
10. Pull Trigger Assembly down to expose airlines.
11. Disconnect airlines from body (3 each).
Note: Use care when removing airlines. Inspect
after removal to ensure no tears took place
during removal.
12. Disconnect Eye Sensor Harnesses (2 each).
13. Disconnect Air Valve from harness (green/black
or black/black wire).
14. Remove Air Valve retaining screw; pull Air Valve
through top of trigger frame for removal.
15. Remove ON/OFF switch retaining screws (2
each).
16. Push down on power indicator light; pull from
backside to remove.
17. Remove Trigger Micro-switch retaining screws (2
each).
18. Remove harnesses from trigger frame. Use
caution when pulling eye sensor part of harness
through top of trigger frame.