Manual

Intimidator-2
WARNING
Make sure marker is not shooting at a dangerous velocity.
Ensure all participants are wearing the proper paintball safety
equipment. You will be held liable if someone is hurt by a
paintball fired from your marker regardless of fault.
WARRANTY
B.L.A.S.T. warrantees the Intimidator against damages in manufacturing and defects.
Electrical components are warranted for a period of 90 days. Wire harnesses located
within the grip frame will only be warranted against manufacturing defects.
For questions concerning your Intimidator manual please call [phone].
THEORY OF OPERATION
The Intimidator marker is a solenoid controlled open-bolt design, very similar to the
popular open-bolt blowback design found in the Spyder. The primary difference is that
instead of a blowback re-cocking on a spring-loaded striker, the bolt is locked into a dual
pressurized machined slider. The back of the chamber is pressurized to move the bolt
forward, and the front is pressurized to move the bolt backward. This allows for very
low cycling pressure, as well as much less cocking recoil. An electronic 4-way valve
controls this slider.
GENERAL DESCRIPTION
The marker includes dual regulators. Both regulators are mounted on the front of the
Intimidator, with standard 3/8-in. hex key velocity adjustments. The high-pressure
regulator is mounted at the top of the regulator base and maintains the firing rate of the
Intimidator. The low-pressure regulator, which is mounted directly below high-pressure
regulator, maintains the cycling rate. All functions are electronically controlled via a
circuit board and 4-way air valve. Settings are changed via a 2-button, internally lit
Liquid Crystal Display (LCD) screen. Rates of fire are variable from 8.1 to 14 balls per