Manual

Intimidator-22
Marker fires with first shot
extremely slow.
Poppet O-ring is dry. Grease Poppet O-ring.
High Pressure Regulator is
set to low.
Increase pressure in High
Pressure Regulator.
Marker cycles but does not
fire.
Dwell is set to low. Set Dwell, green and black
wire Air Valve requires a
#16 Dwell setting, double
black wire Air Valve
requires #6 Dwell setting.
Regulator Pin Valve has
debris lodged between
valve and seal.
Remove debris from
Regulator Pin Valve.
Regulator/Regulators
pressure will not adjust.
Pin portion is bent causing
unreliable seal.
Remove and replace Pin
Valve.
Unexplained ball breakage
and Sensor Eyes are fine.
Ball Sizer was not installed
at barrel attachment.
Install ball sizer and re-
attach barrel. If your
marker does not have ball
sizers, upgrade the type of
paint your shooting
Gun leaks down barrel. Setscrew used to retain
sleeve has become loose
causing sleeve to move
rearward.
Remove sleeve and replace
front 015 o-ring (placing
teflon tape in groove before
seating o-ring). Re-install
sleeve. Use caution to
ensure you do not cut o-
rings. Use lock-tite on
retaining screw.
Inconsistent velocity. High-pressure regulator
piston dry.
Large ram o-ring (rear) is
worn.
Paint does not fit barrel.
Lube piston
Replace o-ring
Use appropriate size of
paintball