Manual

Intimidator-20
MAINTENANCE
WARNING
DO NOT use lightweight oil on marker. Oil will destroy internals
of Air Valve, O-rings, and Cup Seal.
General
Provide all O-rings within the marker a heavy coat of grease. The Poppet and Ram
O-rings need to be greased between 2000-3000 rds. fired. Keep foreign obstructions
out of marker internals.
Regulator
Regulator O-rings should be greased every 5000 rds. fired. Failure to do this will
reduce recover time of Regulators. Additionally, the piston will wear a grove in
Regulator housing. Ensure the Pin Valve lines up with the cup on the Piston. This
will eliminate the inadvertent bending of the pin.
Consumables
Component/Quantity Size
Body Assembly
Bolt (3) .....................................................................................................................015
Poppet (1)................................................................................................................004
Ram Front (1) ..........................................................................................................006
Ram Rear (1)...........................................................................................................011
Pressurized Sleeve (2).............................................................................................015
Sleeve End Cap (1)..................................................................................................011
Cup Seal (1).........................................................................................order from Delta
Regulator Assembly
HPR Housing (1)......................................................................................................016
HPR Piston (1).........................................................................................................113
HPR Pin Valve Base (1)...........................................................................................010
HPR Pin Valve (1).........................................................................................006 Teflon
LPR Housing (1) ......................................................................................................016
LPR Piston (1) .........................................................................................................113
LPR Pin Valve Base (1) ...........................................................................................010
LPR Pin Valve (1) .........................................................................................006 Teflon
Regulator Base (2)...................................................................................................015
Trigger Assembly
Airline (standard Autococker)........................................................ (To regulator) 5.0 in.
(To middle body) 5.0 in.
(To rear body) 2.5 in.
Circuit Board (2).......................................................................................................004