Manual

Intimidator-19
q Sleeve Installation: Use caution when installing
the sleeve. Be careful not to cut the o-rings on
the sharp openings.
q Air Barb: Ensure fiber washer is on air barb base
prior to installation. This will ensure proper seal.
q Cup Seal: Ensure cup seal snaps into sleeve
seal. Failure to do this will allow the cup seal to
jump from seat, causing an extreme air leak.
q Poppet installation: Ensure poppet o-ring is well
greased. Allow poppet to slide into sleeve, once
seated tap on poppet end to mate poppet with
cup seal.
q Sleeve retaining allen: Use small amount of lock
tight on allen when installing. Failure to do this
may result in sleeve sliding back, causing
extreme damage to the marker and possible
injury to the operator.
q Eye Sensor Harness: Ensure harness is seated
in grove provided before attaching Eye Covers.
Failure to do this could pinch the wires and
render the eyes inoperable.
q Eye Covers: Do not over tighten the covers.
Over tightening will result in the cracking of the
covers.
Note: The feeder neck is installed with black
max at the factory. To remove the neck, loosen
the allen at the base of the neck, apply heat and
unscrew. Do not attempt to remove the neck
without first removing the retaining allen. Failure
to do this will result in the damage of the neck.