Manual

Intimidator-17
Regulator Disassembly
1. Remove regulator base retaining screw (1 each).
2. Remove poppet spring.
3. Unscrew high-pressure regulator housing.
4. Remove piston.
5. Remove regulator spring.
6. Remove regulator spring washer.
7. Remove velocity adjustment allen.
8. To remove low-pressure regulator repeat steps
3 through 7.
9. Remove high-pressure pin valve assembly.
10. Remove low-pressure pin valve assembly.
11. Remove air barb from backside of regulator
base.
Note: At this time the Regulators are
disassembled. Listed below are key points to
remember when assembly occurs.
q Piston: Ensure cupped small end of piston is
facing towards pin valve (unless high pressure
regulator is converted to low pressure).
q Regulator Spring: Ensure orange spring is in
high-pressure regulator housing and dark gray
spring is in low-pressure regulator housing.
Failure to do this will cause regulators not to
function properly.
q Pin Valve: Ensure pin valve is not bent and seats
in cupped small end of piston. Failure to do this
will cause regulators not to function properly.
q Air Barb: Ensure fiber washer is on air barb base
when installing. This will ensure air barb does
not leak.
q Poppet spring attachment: Ensure small end of
spring sits firmly on poppet.
q Base Attachment: Place small portion of lock
tight on retaining screw when installing. This will
ensure regulator base does not loosen up during
operation.