Manual

Intimidator-7
OPERATION
GAS CONFIGURATIONS
CO2
When operating the Intimidator on CO
2
it is strongly recommended to use a form of
the following:
• High Flow Expansion Chamber
• CO
2
specific Regulator
• Bottom Line w/tilt
• Anti-Siphon Tank
• Remote with Harness Mounted Tank
Preset HPA/Nitrogen
When utilizing a preset HPA/Nitrogen system it is best to use an external regulator.
This reduces the possibility of over pressurizing the o-rings. Factory recommends
500 psi as output pressure. As most preset systems are around 800 to 850 psi
output pressure, using an external regulator provides the opportunity to reduce output
pressure to the factory recommended 500 psi. The internal high-pressure regulator
continues to remain the dominant high-pressure regulator over the external regulator.
Therefore, velocity adjustments will continue to be made at the internal high-pressure
regulator.
Adjustable HPA/Nitrogen
This is the factory recommended means of airflow for the Intimidator marker.
By setting the output pressure to 500 psi satisfies the air requirement for
the marker and does not allow over pressurizing of the o-rings.