User's Manual

18
CAUTIO N: READ ALL WARNINGS BEFORE USING OR ATTEMPTING ANY WORK ON
YOUR MARKER. SHOULD YOU BE UNSURE AT ANY POINT, STOP AND SEEK
PROFESSIONAL SUPPORT.
11. Q: What items are recommended to keep in my toolkit?
A: Each of the following:
• Pressure tester
• Dow 55
• Triflow oil
• O-rings
• One wooden chopstick (occasionally helpful for poppet or ram removal)
• Hex key set
12. Q: How do I reset the settings to factory on the stock board?
A: Hold the tourny lock for 10 seconds once in programming mode.
13. Q: My feedneck isn’t tightly clamping my loader- what should I do?
A: Use a hex wrench to tighten the adjustment screw.
14. Q: I can’t seem to get an adjustment screw on my trigger to move – what should I do?
A: Most triggers have blue Loctite on the adjustment screw. Just apply some steady force
with the hex wrench and the screw will move.
15. Q: Where can I find additional information and other users of Bob Long Markers?
A: www.intimidatorowners.com also the PBNation subforums dedicated to Bob Long
products located at http://www.pbnation.com/forumdisplay.php?f=146
16. Q: I need to ship my marker in for technical support – what is the address?
A: The address varies depending on whether shipping by postal service or another method.
USPS/postal shipping:
Bob Long Technologies
P.O. Box 457
Mokelumne Hill, CA 95245
Other shipping methods:
Bob Long Technologies
11669 Highway 26
Mokelumne Hill, CA 95245