User's Manual

CAUTIO N: READ ALL WARNINGS BEFORE USING OR ATTEMPTING ANY WORK ON

YOUR MARKER. SHOULD YOU BE UNSURE AT ANY POINT, STOP AND SEEK

PROFESSIONAL SUPPORT.

Maintaining the Poppet Valve

Accessing the Poppet

Poppet valve maintenance is rarely required and incorporates parts of previous maintenance steps.

1. Begin by removing the bolt, back cap,

and ram.

2. Remove the eye cover screws,

detents, and the eye PCB retaining

screws. You can leave the eyes

connected to the wiring harness.

3. Remove the LPR from the front of the

marker.

4. Loosen the rear grip frame screw,

accessible from the top of the marker

through the ram area, approximately

1.5 turns. This screw does not need to

be removed.

5. Loosen the bottom screw on the feed

neck. Leave the feedneck in place

until you remove the other screws.

6. Remove the two forward facing body

screws.

7. Remove the front grip frame screw

located between the HPR and the

trigger guard.

8. Tilt the body up slightly from the grip

frame

9. Remove the feedneck then slide the

front body half forward and off of the

back half.

10. The tapered poppet return spring

may fall free from the poppet, if not,

pull it off and place it to the side.

11. Remove the poppet valve from the

rear of the marker. Fingers, needle

nose pliers, or pushing it from the ram

area with a wooden chopstick all

work.