User's Manual

2. Set dip switch 6 to the (On) position.
3. Pull and hold trigger while powering on board.
4. When LED turns white release trigger.
5. LED will turn off and then flash current Dwell setting.
6. LED will then turn green awaiting your response.
7. Pull trigger to set desired Dwell. Example: Dwell of 8ms = 8 trigger pulls.
8. LED will flash back the Dwell setting you programmed then the board will power itself off.
9. Set dip switch 6 back to the (Off ) position then reboot your board.
International Programming Options
Frenzy 3.0 European Mode ( Removal of 3-shot burst and Full-automatic modes )
1. Power off board.
2. Set dip switches 4 and 5 to the (On) position.
3. Pull and hold trigger while powering on board.
4. When LED flashes white press power button once, then LED will turn aqua.
5. Release trigger and LED will turn green awaiting your response.
6. Pull trigger 10 times then wait until board powers itself off.
7. Set dip switches 4 and 5 back to the (Off ) position.
8. When you power on your board it will be locked in European Mode.
9. Use dip switch 3 to cap your BPS output in compliance with tournament regulations.
Frenzy 3.0 Australian Mode ( Semi-automatic mode only )
1. Power off board.
2. Set dip switches 4 and 5 to the (On) position.
3. Pull and hold trigger while powering on board.
4. When LED flashes white press power button once, then LED will turn aqua.
5. Release trigger and LED will turn green awaiting your response.
6. Pull trigger 13 times then wait until board powers itself off.
7. Set dip switches 4 and 5 back to the (Off ) position.
8. When you power on your board it will be locked in Australian Mode.
9. Use dip switch 3 to cap your BPS output in compliance with tournament regulations.
4C® is a registered trademark of Extreme Paintball Design, LLC patent pending