User's Manual

9. Set dip switch 2 back to the (Off ) position then reboot your board.
Dip Switch 3 Programmable BPS ( balls per second )
Note: Stock setting is Unlimited BPS. BPS setting is programmable from 11 to Unlimited.
To check current BPS setting:
1. Power off board.
2. Set dip switch 3 to the (On) position.
3. Power on board.
4. LED will flash current BPS setting then board will power itself off.
To set desired BPS:
1. Power off board.
2. Set dip switch 3 to the (On) position.
3. Pull and hold trigger while powering on board.
4. When LED turns white release trigger.
5. LED will turn off and then flash current BPS setting.
6. LED will then turn green awaiting your response.
7. Pull trigger to set desired BPS. Example: 13 BPS = 3 trigger pulls.
1 pull = 11 BPS
2 pulls = 12 BPS
3 pulls = 13 BPS
4 pulls = 14 BPS
5 pulls = 15 BPS
6 pulls = 16 BPS
7 pulls = 17 BPS
8 pulls = 18 BPS
9 pulls = 19 BPS
10 pulls = Unlimited BPS
8. LED will flash back the BPS setting you programmed then the board will power itself off.
9. Set dip switch 3 back to the (Off ) position then reboot your board.
Dip Switches 4 and 5 Programmable Fire Modes
(Off ) (Off ) = Normal semi-automatic mode
(Off ) (On) = 3-shot burst mode (activated when 4 BPS is achieved)
(On) (Off ) = Ramping mode (activated when 4 BPS is achieved)
(On) (On) = Full-automatic mode (activated when 4 BPS is achieved)
Dip Switch 6 Programmable Dwell
Note: Stock Dwell setting is 8ms. Dwell is programmable from 4ms to 25ms.
To check current Dwell setting:
1. Power off board.
2. Set dip switch 6 to the (On) position.
3. Power on board.
4. LED will flash current Dwell setting then board will power itself off.
To set desired Dwell:
1. Power off board.