User's Manual
B
B
o
o
b
b
L
L
o
o
n
n
g
g
i
i
n
n
t
t
i
i
m
m
i
i
d
d
a
a
t
t
o
o
r
r
B
B
o
o
b
b
L
L
o
o
n
n
g
g
i
i
n
n
t
t
i
i
m
m
i
i
d
d
a
a
t
t
o
o
r
r
Assembly and Disassembly
REGULATOR DISASSEMBLY (continued)
TORPEDO/HIGH-PRESSURE REGULATOR
(
HPR
)
1. Unscrew Allen Adjuster.
2. Unscrew Lower End of
(
HPR
)
High-Pressure Regulator Housing.
3. Remove Regulator Spring Washer.
4. Remove Regulator Spring.
5. Remove Piston.
NOTE: At this time the Regulators are disassembled. Listed below are key elements to
remember during assembly.
1. Piston:
Ensure narrow, cupped end of Piston is facing towards Pin Valve.
2. Pin Valve: Ensure Pin Valve is not bent and seats in cupped small end of Piston.
Failure to do so will cause Regulators to function improperly.
3. Air Barb: Ensure fiber washer is on Air Barb base when installing.
This will ensure Air Barb does not leak.
4. Poppet Spring Attachment: Ensure small end of Spring sits firmly on Poppet.
5. ASA Block: Place small portion of Loctite on Retaining Allen when installing.
This will ensure ASA (regulator) Base does not work itself loose during operation.
6. Remove Pin Valve Retainer.
7. Remove Teflon Washer.
8. Remove Pin Valve.
9. Remove Spring from Upper Reg. Housing.
10. Upper End of
(
HPR
)
High-Pressure
Regulator Housing.
6. Remove Pin Valve Retainer.
7. Remove Teflon Washer.
8. Remove Pin Valve.
9.
Remove Spring from Upper Reg. Housing.
10. ASA End of
(
LPR
)
Low-Pressure
Regulator Housing.
2005
Torpedo/High-Pressure Regulator
35 48 67910 12
LOW PRESSURE REGULATOR
(
LPR
)
1. Unscrew Allen Adjuster.
2. Unscrew Adjustment End
(
Part 2
)
from ASA
End
(
Part 10
)
of Low-Pressure Regulator.
3. Remove Regulator Spring Washer.
4. Remove Regulator Spring.
5. Remove Piston.
Low-Pressure Regulator
3 54 86 7 9 101 2
Assembly and Disassembly
II. REGULATOR DISASSEMBLY
ASA BLOCK/HOUSING
First: Remove Both Regulators.
1. Remove Air Barb from ASA Block.*
2. Remove Regulator Base Retaining
Screw from Body.
3. Slide Regulator Base from Body.
4. Remove Spring and Poppet.
*
Use great caution when Removing or Reinstalling Air Barbs as they are somewhat delicate. Air Barb on front Block must be
removed in order to gain proper acces to Regulator Base Retaining Screw. Failure to do so may result in damage to the Air Barb.
Remove ASA Retaining Allen Slide Regulator Base from Body Remove Spring and Poppet
234
Remove Air Barb from ASA Block
1
13
14
Bob Long Manual ƒ 4/20/05 4:59 AM Page 16