User's Manual

BOB LONG GZ INTIMIDATOR – PAGE 8
OPERATION
GAS CONFIGURATIONS
CO2
When operating the Intimidator on CO2 it is strongly recommended to use a form of
the following:
q High Flow Expansion Chamber
q CO2 specific Regulator
q Bottom Line w/tilt
q Anti-Siphon Tank
q Remote with Harness Mounted Tank
Preset HPA/Nitrogen
When utilizing a preset HPA/Nitrogen system it is best to use the optional expansion
attachment (reference expansion attachment Conversion). Failure to do this will
result in the over pressurization of the o-rings. Factory recommendations are 500 psi
to the regulators. As most presets are around 800 to 850 psi output pressure,
therefore the use of an external regulator is recommended. This transforms the high-
pressure regulator into an expansion chamber. Now the main high-pressure
regulation falls on the vertical regulator.
Adjustable HPA/Nitrogen
This is the factory recommended means of airflow for markers not utilizing optional
expansion attachment. By setting the output pressure to 500 psi satisfies the air
requirement for the marker and does not allow over pressurizing of the o-rings.
AMMUNITION ASPECTS
Hopper
The Intimidator requires a high flow of paintballs to make full use of its features. To
satisfy this the use of the motorized loaders are recommended.
Paint
Using top grade paint ensures the utmost in performance and accuracy.