User's Manual

BOB LONG GZ INTIMIDATOR – PAGE 25
LPR Pin Valve Base (1) ......................................................................................................010
LPR Pin Valve (1) .................................................................................................... 006 Teflon
Regulator Base (2)...............................................................................................................015
Trigger Assembly
Airline (to regulator base) ...............................................................................................5.0 in.
Airline (to middle body) ...................................................................................................5.0 in.
Airline (to rear body) ........................................................................................................2.5 in.
Circuit Board (1).......................................................................................................004
TROUBLESHOOTING
Note: Refer to Assembly/Disassembly to perform repairs indicated below.
Problem Cause Repair
When gas is applied to the
gun a load POP is heard
and air is escaping in our
around the Trigger Frame.
Airline or lines have
become stretched or
disconnected from Ram
Sleeve (usually due to
over-pressurizing of the
Regulators).
Re-connect airline.
Replace stretched/leaking
airline.
The Low pressure
Regulator is over-
pressurized and causing
the Air Valve to leak.
Turn down Low Pressure
Regulator.
Foreign Material has
lodged inside Air Valve.
It is not recommended to
disassemble the Air Valve.
Remove and return Air
Valve to factory.
Gun leaks from inside the
Trigger Frame and hoses
are fine.
Heavy use of lightweight oil
ion marker causing internal
destruction of Air Valve.
It is not recommended to
disassemble the Air Valve.
Remove and return Air
Valve to factory.
Gun consistently leaks
down the barrel,
decreasing slightly when
bolt is pushed forward.
Heavy use of lightweight oil
causes deterioration of
Poppet O-ring and/or Cup
Seal.
Remove Poppet and
replace O-ring. Remove
and replace Cup Seal.