User's Manual

BOB LONG GZ INTIMIDATOR – PAGE 24
MAINTENANCE
WARNING
DO NOT use lightweight oil on marker. Oil will destroy internals
of Air Valve, O-rings, and Cup Seal.
General
Provide all O-rings within the marker a heavy coat of grease. The Poppet and Ram
O-rings need to be greased between 2000-3000 rds. fired. Keep foreign obstructions
out of marker internals.
Regulator
Regulator O-rings should be greased every 5000 rds. fired. Failure to do this will
reduce recover time of Regulators. Additionally, the piston will wear a grove in
Regulator housing. Ensure the Pin Valve lines up with the cup on the Piston. This
will eliminate the inadvertent bending of the pin.
Consumables
Component/Quantity Size
Body Assembly
Bolt (3)...................................................................................................................................015
Poppet (1) .............................................................................................................................004
Ram Front (1).......................................................................................................................006
Ram Rear (1)........................................................................................................................011
Pressurized Sleeve (2)........................................................................................................015
Sleeve End Cap (1).............................................................................................................011
Cup Seal (1).................................................................................................... order from Delta
Regulator Assembly
HPR Housing (1)..................................................................................................................016
HPR Piston (1) .....................................................................................................................113
HPR Pin Valve Base (1) .....................................................................................................010
HPR Pin Valve (1).................................................................................................... 006 Teflon
LPR Housing (1)...................................................................................................................016
LPR Piston (1) ......................................................................................................................113