User's Manual

BOB LONG GZ INTIMIDATOR – PAGE 23
Note: At this time the Body is disassembled. Listed below are key points to
remember when assembly occurs.
q O-rings: Apply grease to all o-rings before installing.
q Front Sleeve O-ring: Ensure o-ring is in good shape upon install.
q Sleeve Installation: Use caution when installing the sleeve. Be careful not to
cut the o-rings on the sharp openings.
q Air Barb: Ensure fiber washer is on air barb base prior to installation. This will
ensure proper seal.
q Cup Seal: Ensure cup seal snaps into sleeve seal. Failure to do this will allow
the cup seal to jump from seat, causing an extreme air leak.
q Poppet installation: Ensure poppet o-ring is well greased. Allow poppet to slide
into sleeve, once seated tap on poppet end to mate poppet with cup seal.
q Sleeve retaining allen: Use small amount of lock tight on allen when installing.
Failure to do this may result in sleeve sliding back, causing extreme damage to
the marker and possible injury to the operator.
q Eye Sensor Harness: Ensure harness is seated in grove provided before
attaching Eye Covers. Failure to do this could pinch the wires and render the
eyes inoperable.
q Eye Covers: Ensure ball detents remain aligned and in covers upon install. Do
not over tighten the covers. Over tightening will result in the cracking of the
covers.
Note: The base of the feeder neck is pressed in at the factory. To remove the
neck, simply unscrew feeder neck top. Do not attempt to remove the
neck base. Failure to do this will result in the damage of the feeder neck.