User's Manual

BOB LONG GZ INTIMIDATOR – PAGE 21
Body Disassembly
1. Ensure barrel of marker is removed.
2. Remove Eye Sensor covers (both sides) by
removing retaining screw (1 each side).
3. Remove Eye Sensor Harness (both Sides)
by carefully pulling sensor heads from
mounting holes. Be careful not to loose
small o-ring on each head.
4. Lift up on bolt-retaining pin and slide bolt
out of rear of marker.
5. Remove rear sleeve cap screw.
6. Turn marker up and allow ram to fallout of
marker rear. Hold hand underneath to
catch ram. Do not let ram fall freely on to
ground or any other hard surface.
7. Remove poppet from sleeve front. Use a
small pair of pliers to grab poppet end. Do
not use force on poppet. Poppet will come
out with little or no pulling pressure. Use
care not to damage poppet lip. Damaging
poppet lip will not allow the poppet to seal
properly to the cup seal.