User's Manual

BOB LONG GZ INTIMIDATOR – PAGE 20
Note: At this time the Regulators are disassembled. Listed below are key
points to remember when assembly occurs.
q Piston: Ensure cupped small end of piston is facing towards pin valve.
q Regulator Spring: Ensure orange spring is in vertical regulator housing and
dark gray spring is in Horizontal regulator housing.
Failure to do this will cause regulators not to function properly.
q Pin Valve: Ensure pin valve is not bent and seats in cupped small end of piston.
Failure to do this will cause regulators not to function properly.
q Air Barb: Ensure fiber washer is on air barb base when installing. This will
ensure air barb does not leak.
q Poppet spring attachment: Ensure small end of spring sits firmly on poppet.
q Base Attachment: Place small portion of lock tight on retaining screw when
installing. This will ensure regulator base does not loosen up during operation.