User's Manual

BOB LONG GZ INTIMIDATOR – PAGE 18
24. Remove Trigger shouldered screw and
remove Trigger.
25. Remove Trigger Guard screws (2) and
remove Trigger Guard.
Note: When removing Trigger ensure not to
loose Trigger Spring.
26. If required use allen to back out Trigger
adjustment screws. If not required leave
allen’s adjusted to maintain original
adjustment.
Note: At this time the Trigger is disassembled. Listed below are key points to
remember when assembly occurs.
q LCD Install: Ribbon comes pre-folded from the factory. Fold ribbon and place
screws in LCD before placing into trigger frame. Start all screws in all holes prior
to tightening.
q Trigger Micro-Switch: When installing Trigger Micro-switch, ensure hinged
portion is on top.
q Circuit Board: Do not over tighten the circuit board. Lay harness in trigger
frame to avoid pinching of wires when attaching Trigger halves.
q Harness Connection: When connecting to the circuit board ensure orange wire
is up on 12-point harness and black and red wire is up on 14-point harness.
q Airline Attachment: Ensure airlines are seated on air barb bases. This will
prevent the possibility of air leaks. Do not pinch airlines when routing through
trigger halves.
q Eye Sensor Connection: After connecting eye sensor harnesses pull remaining
wire through trigger halves. This avoids pinching of wires during trigger frame
attachment to body.
q Trigger Assembly Attachment: When you have finished assembly of the trigger
frame and are ready to attach to body, ensure screw with washer goes in the
front. Failure to do this will result in the puncture of the pressurized sleeve.