User Manual

1. Please think of this manual as your map. Knowledge of Bluetooth and device
connection is essential for the steering of this boAt. Therefore, we strongly advise
that this manual is thoroughly read before beginning use, and referred to when
in times of difficulty.
2. Please do not let the earbuds come into contact with sharp edges, uneven surfaces,
and metal parts, in a manner that can lead to some form of permanent external
or internal damage.
3. Please don’t dismantle the product in any way, it can lead to a fire or electrical
breakdown and even completely damage the product. As this is extremely unsafe, we
ask that any maintenance of servicing of the headphones is done only through a
qualified service provider/manufacturer.
4. Please do not remove the battery by yourself, this is a task meant to be managed by a
service provider/manufacturer. Replacing the current battery with an ill-fitting set can
result in a fire or electric hazard, therefore it is strongly advised against.
5. Please clean the earbuds with the utmost of care with only a damp soft cloth, if
cleaning is required. Please do not use any oily volatile liquid. In addition, ensure that
the Headsets are kept away from extremely hot or cold substances.
6. To avoid damage to your hearing, make sure that the volume on your music player is
at an appropriate level when you are plugging into Nirvana. After wearing the earbuds,
gradually turn up the volume until you reach a comfortable listening level. Exposure
to any noise levels at or above 85 dB can gradually lead to a loss of hearing.
Therefore, listening sessions that are at higher volumes should not be for too long.
If you are planning to use the earbuds for extended periods of time, it is safer to keep
the volume at a low level.
7. Any damage to the earbuds that is NOT a manufacturing issue will make the products
warranty null and void. Please take the greatest care of your headphones to ensure
that no such occurrences take place.
8. Do not use earbuds when it is unsafe to be wearing them, such as while operating a
vehicle, crossing a street, or during any activity where full awareness of your
surroundings is required. This is because it is dangerous to drive while wearing
headphones as it decreases your ability to hear sounds like another car’s horn or an
emergency vehicle’s sirens. Therefore, please avoid wearing your Headsets
while driving.
Cautions:
Advisable: The earbuds will start at a 100% volume, and may need to be reduced
when first switched on. This can done using the volume control on your bluetooth
201
Basic Functions
Please Note: The Volume can not be controlled via your Earbuds,
and can only be adjusted through your device.
NOTE: Single Earbud Use will only function on the Right earbud.
Manual Power Off:
Your AirDopes 201 Earbuds will automatically Power On
once taken out of the Charging Case. To Power Off follow below steps.
STEP 1 : After use, remove both left and right earbuds from your ear.
STEP 2 : Place & put back both the earbuds into the Charging Case.
STEP 3 : If LED is showing, it means it is charging.
Smart Power OffVoice Assistant
STEP 1 : If both earbuds are on, long Press
either left or right earbuds for 5 Seconds
to manually power off the Earbuds.
Please note, this will power off both the
earbuds.
STEP 2 : Place them back into the
charging case to charge the earbuds.
Factory Reset/Solution:
Perform below tasks if you ever face any difficulties with your Airdopes 201.
Step 1. Put both earbuds In the Charging case, this will put them in charging mode.
Step 2. Now Long Press MFB for 5 seconds on both the earbuds (While the earbuds
are inside the Charging Case). Wait for Orange/White Lights to blink.
Step 3. Release Fingers. then take out both the earbuds out of the Charging Case.
R & L Earbuds will pair with each other, Right side will blink Orange/White.
Step 4. Your Earbuds are now ready to be paired with any bluetooth device.
Step 5. Refer to page 4 for Power ON and Page 5 for Connection Mode.
Performing a Reset:
STEP 1 :
Long Press the MFB on either
Left or Right Earbud for
2 Seconds to Activate
Google / Siri Voice
Assistant.
STEP 2 :
Google / Siri Assistant Screen will
pop up & you may command
at ease.
TIPS: You may try the following commands
“What is the weather?”
”Open Camera.”
“Play my Playlist”
• Voice Assistant- Press the multifunction button for 2 seconds to activate
voice assistant.
• Answer/Hang up phone call- Tap the multifunction button once to answer
any incoming call and once again to hang up once done talking.
• Rejecting phone calls – Press and hold the Multifunction button for 2
second to reject an incoming call.
• Play/Pause – Tap the multifunction button to play/pause music at your
convenience.
• Next Track - When playing music, double click the right earbuds
multifunction button to play the next track.
• Previous Track - When playing music, double click the left earbuds
multifunction button to play the previous track.
Please Note: Since Right Side is the Master Earbud, Orange/White Light will only Blink on R Earbud.
L Side will only Flash White light every 6 seconds.
Potential Problem
Left Earbud disconnects during
phone call
Left Earbud disconnects during
phone call
About 20 seconds delay or easy
disconnect for left earbud
Occasional disconnect and recover
minutes later
If there are other exceptions in use
Place the earbuds in the charging
case and then try using them again.
It will connect automatically.
Try re-setting the device.
Power off, then switch on once
more
Power off, then switch on once
more
Place the earbud’s in the charging
case and then try using them again.
If this does not work, try re-setting
the device
Solution
TroubleshootingCommon Problem With Solution
If Earbuds not in scan mode:
If one side only working, then simply
put back both earbuds In case or
perform “Factory Reset”.
If Earbuds not in Scan mode (No
Orange/White LED blink on left
Earbuds) Simply put back both the
earbuds in case and take out again or
perform “Factory Reset”.
If one side working only:
Specifications
Battery of headset
Charging voltage of
headset
Charging time of headset
Battery of box
Charging voltage of box
Charging time of box
Earphone weight
Charging box weight
50mAH Li-polymer
Battery
5V
1.5hours
470 mAH Li-
polymer Battery
5V
1.5hours
7g x 2pcs
50g
Bluetooth version
Music Play time
Talk time
Standby time
Driver
Sound pressure level
Frequency response
V5.0
3 hours
3 hours
40 hours
Up to 3.6ft./12m
HFP1.7/A2DP1.3/
AVRCP1.5
10mm
98±3dB
20Hz---20 KHz
Water Resistance
IPX4
Charge The Case
Charge The Earbuds
Warning: please do not charge the carrying case with “9V” or “12V” output.
Otherwise, it may cause damage to the case.
• To charge the case, plug in the USB cable and connect it to any USB port.
• The 4 lights aligned vertically in the center of the charging case indicate
the charge/battery status.
• 4 lights are illuminated for 60 seconds once the case has been completely
charged
• The earbuds can be charged a total of 4 times if the case is at full battery
• Put the boAt Airdopes 201 back into the charging case in their correct
orientation.
• A Orange light on the earbud’s will indicate they are still being charged.
This light will go off once the earbud’s have been completely charged.
• When both two earbud’s are fully charged, the carrying case will switch
off to save power.
LED Indicators / Functionalities
STEP 1 :
Take out the
Earbuds out of the
Charging Case.
STEP 2:
Please wait, Both Earbuds will automatically pair to each other.
They will blink for 3 seconds & automatically connect to each other.
Wait for Orange/White LIGHTS on the Right earbud & Left Earbud
will stop blinking. This “Orange/White LIGHTS” means that it has
gone into Connection Mode.
Right Earbuds is the Master Earbud, LED Indicators will only blink
on the right one during this stage.
NOTE: IF LEFT IS STILL BLINKING , DO FACTORY RESET LIKE IN PAGE 12
LED Indicators will
NOT blink on the
left Earbud
LED Indicators will
blink on the
right Earbud
Power ON (First time user)
STEP 1 : At this stage your earbuds are in stereo mode & connected
to your bluetooth device.
STEP 2 : Simply remove left earbud from your ear.
STEP 3 : And, place the Left Earbud back into the Charging Case.
STEP 4 : Congratulations, you are now using mono/solo mode.
NOTE: Right Earbuds is the Master Earbud, Single Earbud use will only function on
the Right earbud.
NOTE: To switch to stereo mode, simply take out the left earbud out of
the case & place it in your ear. The left earbud will automatically power
on & pair with your right earbud hence enabling it for stereo usage.
Single Earbud Use
3 Seconds
2 Seconds
Manual Power ON:
Orange Lights will Blink.
Long Press MFB on either earbud
for 2 Seconds to activate Voice
Assistant. / Reject incoming Calls.
Manual Power OFF
Scan Mode:
Orange & White Lights will
Blink rapidly.
Factory Reset: Put the earbuds inside the
case and Long Press MFB for 5 seconds
Orange/White Lights will Blink on
both Earbuds.
5 Seconds
5 Seconds
(While Earbuds
Inside Case)
Multi
Function Button
( MFB )
NOTE: Factory Reset will remove all device profiles
saved on the Airdopes 201
NOTE: If the earbuds don’t automatically Power On when taken out of charging case.
STEP 1: Long Press MFB* on right earbud first, then Long Press MFB* on left earbud.
This will power on both the earbuds. Wait for Orange/White LIGHTS on the right earbud.
This “Orange/White LIGHTS” means that it has gone into Scan Mode.
STEP 3:
Turn on bluetooth on your device & then scan.
STEP 4:
Search for “boAt Airdopes 201” and pair accordingly.
Congratulations, your earbuds are now connected succesfully.
STEP 5:
You may now enjoy your music or
any other entertainment form factor
Enter the password “0000” if asked
for, and connect the earbuds to
your device.
“MFB” Stands for Multi Function Button.
Bluetooth
BoAt Airdopes 201
Connection Mode
In the box
1x boAt Airdopes 201
1x Charging Case
1x USB charging cable
2x pairs of additional earmuffs (S & M & L)
User Manual
1
2
3
4
5
Product Overview
1
2
MFB (multifunction button)
Indicator light
4
Charging Case indicator
1
2
4
3
3
Charging contact point
5
Micro USB charging port
5
Get ready to ride the waves of Nirvana with your all
new boAt Airdopes 201. Please think of this manual
as your map. Knowledge of Bluetooth and device
connection is essential for the steering of this boAt.
Therefore, we strongly advise that this manual is
thoroughly read before beginning use, and
referred to when in times of difficulty. We hope
you’re ready to Plug Into Nirvana.
201
MANUAL
SETUP GUIDE
• WH AT S IN THE BOX
• POWER ON/OFF
• CONNECTION MODE
• LED INDICATORS
• SINGLE EARBUD USE
• CHARGING
• FUNCTIONS
• VOICE ASSISTANT
• FACTORY RESET
201
2 3 4 5 6 7 8
10
9
11
12
13
14 15