Installation Guide

INSTALLATION GUIDE AND MATERIALS GUIDE
INSTALLATION OF BOANN APRON SINKS
General Recommendations:
It is recommended that all installation of Sinks and Faucets be installed by a licensed
professional plumber. Please see warranty information for more details.
Read installation and maintenance instructions thoroughly before installation. Inspect your
sink for any noticeable damage before installation. Check all local applicable plumbing and
building codes.
These instructions are based on application to composite material or solid surface
countertop installation only; countertop application to stone, marble, granite or butcher-
block should be referred to experienced countertop fabricator for custom installation.
BOANN sinks are individually hand-crafted and we suggest using experienced and
professional installers only. For custom cutting of countertop and installation of the actual
sink, on-site installation is also recommended. Acceptable variances are approximately 1/2
of an inch. Alignment to cut-out and precise application and trimming of any adhesive
sealant are critical to a superior fit and finished look. Please take extra care in this regard.
BOANN Apron sinks require custom order cabinets. Consult your cabinet dealer.
BOANN does not accept any liability for damage to countertop, sink fixture, faucets or
personal injury during installation. Warranty is void if installation instructions are not
followed.
Tools and Materials needed:
Tape Measure
Denatured Alcohol
Wood Braces
Pencil (NOT ink)
Ear Protection
Framing Square
Silicone Adhesive Sealant
Eye Protection
Shims
Rags Hacksaw/Jigsaw
Be sure to use proper tools and always wear personal safety accessories for your
protection.