Use and Care Manual

8
boannstyle.com
Preparing the Feed Water to the System
Underneath the sink are located the water supply shut off valves to the Hot and Cold water lines.
Before installation commences, please SHUT OFF the main water supply line and the Hot and
Cold water valves. After, turn on the sink cold water tap to make sure there is no water
owing from the sink faucet. At this point there should be no water owing.
WARNING! Do not attach the system to the Hot water line as hot water will damage the lters
with the system.
Installing the Feed Water Connector
1. After turning off the cold water valve, the detachment of the cold water hose will be required.
With use of a wrench, carefully unscrew the water hose from the cold water valve.
Installation Preparation
Turn Off Cold Water Valve
(Turn Clockwise)
Note!
Please understand even though the instructions contained herein use the
Manual Shut Off Valve to complete installation, the provided supplement Needle
Valve NSV-1 can be used instead of the Manual Shut Off Valve to complete
installation. The installation process is the same.