Use and Care Manual

18
boannstyle.com
Testing the Water Filtration System
After letting the system operate for one (1) hour, turn on the ltration systems faucet and let the
water run for about 1-2 minutes. Invariably you will evaluate dark, murky water coming from the
faucet. This is normal and reects loose particulates and carbon dust being ushed out from the
system. After approximately 2 minutes clean water will be visible, indicating the system is fully
operational and thus producing clean, drinkable water.
This concludes the installation process and you may now start drinking puried water from the
Boann Reverse Osmosis 5-Stage Water Filtration System. Enjoy!
If you require further information and/or clarication regarding the installation process, please
feel free to contact Boann at: [e-mail].
Threaded Fittings
To prevent a leak on any threaded tting that screws into the
Reverse Osmosis 5-Stage Water Filtration System, please
employ Teon tape by way of wrapping the threads of the
various threaded ttings 5-7 times.
This preventative measure will assist in preventing potential
leaks from the threaded ttings throughout the R.O. ltration
system.
If there are signs of leakage from a 1/4” tube
inserted into a threaded tting, simply push and insert the
threaded tting further. To facilitate this process, use pliers
and grab the tubing 1/2” from where the tube inserts into the threaded tting. This will help avoid
damaging the tubing which will be inserted into the threaded tting and invariably prevent
leakage from this location.
R.O. Filtration System Evaluation/Leak Prevention
Tip!
Maintaining the pre-lters of your system is key to ensure the ltration system
sustains integrity in both water quality production and longevity of its parts and
components. The pre-lters are the ltration systems rst line of defense and thus
paramount in promoting the maximum lifespan of the R.O. Membrane.