Use and Care Manual
14
boannstyle.com
Prepare the R.O. Pressure Storage Water Tank
The R.O. Pressure Storage Water Tank has both an air and water bladder built inside it. The air
bladder comes pre-set from the factory at 7 PSI. NOTE: Changes to the PSI of the air bladder
inside the water tank may cause harmful back pressure which can result in damage to
the R.O. ltration system.
Connecting the R.O. Pressure Storage Water Tank
1. Screw the Tank Ball Valve onto the threads located on top of the water tank. For security, apply
5-8 wraps of Teon tape to the thread of the tank.
2. The yellow PE tubing will now be used to connect the system to the R.O. Pressure Storage
Water Tank. Connect the yellow PE tubing into the Tank Ball Valve atop of the water tank and
connect the other end to the Tank input port on the R.O. Filtration System.
Tank Input Port Ports with Elbow Connectors
R.O. Filtration System Installation
Tank Ball Valve
Tip!
The Boann Reverse Osmosis 5-Stage Filtration System comes with 4 elbow
connectors (shown above) which can be used for convenience and facilitate for
diverse placement of the system. The elbow connectors help point tubing in
diverse, desired directions.