Use and Care Manual

10
boannstyle.com
Connecting the Feed Water Line to the Filtration System
Depending on the proximity and distance of the ltration system to both the Auto Leak Detector
and cold water valve, measure the distance between each component and carefully cut the red
PE tubing in half. Take one piece and rmly insert one end into the Inlet port located on the rear of
the system. Attach the other end to the R.O. System Out port on the Auto Leak Detector. Next, use
the other red PE tubing and attach it to the Main Line-In port on the Auto Leak Detector. The other
end of the tubing is already attached to the Manual Shut Off Valve (per previous step).
Inlet Port Manual Shut Off Valve
Auto Leak Detector
IMPORTANT: The Auto Leak Detector comes with an adhesive footing to adhere and hold the
module in a desired location. However, two screws are provided to assist with securing the unit
into place. Insert the two screws into the two side brackets and drill into the surface.
Installation Preparation
To R.O. System - Out
Side Bracket for Screws
From Main
Line - In
(Feed Water)
Note!
Although the Leak Detector is a invaluable safeguard against leakage, it is
considered an optional part and therefore is not required for full system operation.
Therefore, connecting the red PE tubing from the Manual Shut Off Valve to the Inlet
input port on the system will complete water main line system connection.