Instructions / Assembly

16
boannstyle.com
Installation of Standard Faucet
At this point the blue PE tubing will be used to connect the R.O. System to the faucet. The length
of tubing used to hook up the kitchen faucet should be long enough to connect to the Faucet input
port. Take a moment to assess and measure the amount of tubing required for the application.
Once an accurate measurement is taken, cut the blue PE tubing with scissors or a sharp knife.
Make certain the cut is straight and not at an angle.
Now insert one end of the customized blue PE tubing into the Faucet input port on the rear of the
ltration system. The other end will connect to the faucet assembly.
Installation Steps
1. Drill a 1/2” hole in the sink or
counter top, or utilize an
existing hole (should it be the
appropriate size).
2. Slide chrome cover plate and
rubber gasket onto stem of
faucet and place the faucet
onto the sink, with the stem
going through the hole.
3. Attach plastic locating washer
(used where a 1/2” hole is
available, reverse when
mounting on stainless steel or
when using a drilled hole.
Attach metal tooth washer.
4. Tighten the faucet nut from
under the counter surface to
lock the faucet into place.
5. Slide the compression nut and
ferrule onto the blue tubing.
6. Insert the tube inset into the
opening end of the blue tubing.
7. Thread the compression nut
onto the faucet’s threaded stem, securing the blue tubing.
Check over all of the steps. Make sure all of your tubing is inserted rmly into the
respective inputs!
R.O. Filtration System Installation
Counter Top
Chrome Cover Plate
Rubber Gasket
Locating Washer
Metal Tooth Washer
Faucet Nut
1/4” Compression Nut
Blue 1/4” Tubing
1/4” Tube Inset
1/4” Ferrule