Instructions / Assembly

10
boannstyle.com
Using the EZ Angle Stop Adapter
3. Using a wrench, thoroughly tighten the cold water hose onto the male threading of the EZ
Angle Stop Adapter. Note: Adapter should always remain upright, withstanding no stress from
the hose. Cut the red PE tubing in half and push one end of the red PE tubing rmly into the
Collet on the EZ Angle Stop Adapter.
4. Attach the other end of the red PE Tubing to the R.O. System Out port on the Auto Leak
Detector. Next, use the other cut red PE tubing and attach it to the Main Line-In port on the
Auto Leak Detector.
Installation Preparation
To R.O.
System - Out
From Main
Line - In
(Feed Water)
Note!
Although the Leak Detector is an invaluable safeguard against leakage, it is
considered an optional part and therefore is not required for full system operation.
Therefore, connecting the red PE tubing from the Manual Shut Off Valve to the Inlet
input port on the system will complete water main line system connection.