Faucet Parts & Accessories IMPORTANT: Before installing your new faucet, make certain you have all working parts, as indicated below in the diagram.
Product Information Product Dimensions 3
Installation Instructions Step 1 2” (50.8mm) The deck hole should be 1 3/8” (35mm) and the deck thickness should be no more than 2” (50.8mm). Step 2 Shank Hot Cold Install the faucet through the deck mounting hole. Be sure to align the faucet in the desired direction.
Installation Instructions Step 3 1 2 3 4 Install the plastic base (1), gasket (2) and washer (3). Make sure the plastic base is installed with the flat side facing the deck. Next, install the metal base clamp (4). Step 4 1 Use the provided screws by screwing them into the metal base clamp (1). Screw them tightly without stripping the screw heads.
Installation Instructions Step 5 1 2 Insert the pull out hose (1) through the hose holder (2). Step 6 3 2 4 1 After inserting the pull out hose (1) through the hose holder (2), attach the hose holder to the line converter (3). Be sure to insert the rubber washer (4) into the line converter before connecting the hose. Connect the pull out hose (1) to the line converter (3).
Installation Instructions Step 7 1 2 3 The short water line is HOT (1) water, while the longer water line is COLD (2). Securely attach both HOT (Red - 1) and COLD (Blue - 2) water hoses to the faucet. Attach the weight (3) onto the pull out hose at your desired location. Note: The weight should NOT make contact with the faucet line hoses when the faucet head is pulled out. Step 8 1 1 HOT COLD Connect the water hoses (1) onto the water valves (we recommend using plumbers tape to prevent leakage).
Filter Cleaning Step 1 Faucet Aerator Remove the aerator by unscrewing it. Step 2 1 2 3 Separate the rubber washer (1) and filter (2) from the holder (3) and turn on the faucet. Let the water run for 30 seconds to ensure all excess debris flushes out of the faucet. Also, check all faucet connections to ensure there are no leaks.
Filter Cleaning Step 3 Reassemble the aerator and reattach onto faucet head. Step 4 Enjoy the use of your faucet! Note: A small amount of water may run from the spout or drip for a very short period after the faucet is shut off. This is a natural occurrence caused by long, flexible hoses.
Boann Manufacturer Warranty All Boann products are manufactured and tested with the highest quality standards and rigorous quality control process. This warranty is limited to the non-commercial use of Boann products purchased and installed in the United States and Canada.
Boann Manufacturer Warranty responsible for any default breakage, or damages caused thereby or resulting thereof, either directly or indirectly. This warranty does not apply to Products that have not been installed or operated in accordance with instructions supplied by Boann and all applicable rules, regulations, and legislation pertaining to such installations. This warranty does not apply to Commercial or Industrial applications of Boann products.