User Manual

RIGOL Chapter 3 Arbitrary Waveform Output
User‟s Guide for DG5000
3-2
To Enable Arbitrary Waveform
Press Arb to open the operation menu of arbitrary waveform.
1. Freq/Period (Sample)
Set the output “Frequency/Period” of the arbitrary waveform in “Normal” mode.
Set the sample rate when the generator sample data from external memory in
“Play” mode.
2. Ampl/HiLevel
Set the output “Amplitude/High Level” of the arbitrary waveform.
3. Offset/LoLevel
Set the output “Offset/Low Level” of the arbitrary waveform.
4. Phase
Set the “Initial Phase” of the arbitrary waveform.
5. Align Phase
Refer to “Align Phase”.
6. Mode
Select the output mode of the arbitrary waveform to “Normal” or “Play”.
7. Select Wform
Select arbitrary waveform stored in internal or external memories.
8. Create New
Users can define waveform with up to 512k points.
9. Edit Wform
Edit the stored arbitrary waveform.
Refer to “To Output Sine Waveform” to configure the parameters and output. This
chapter will focus on “Mode”, “Sample”, “Select Waveform”, “Create New” and “Edit
Waveform”.