User Manual

RIGOL Chapter 11 Remote Control
User‟s Guide for DG5000
11-4
Remote Control Via LAN
1. Connect the devices
Connect the generator to your LAN using network cable.
2. Configure LAN parameters
Set the LAN parameters of the generator according to the description in
“Advanced Operation  To Configure the Remote Interface”.
3. Search device resource
Start-up Ultra Sigma and click , then the software starts searching the
generator resources that have been automatically connected to LAN. The status
bar of Ultra Sigma at present is shown like the figure below:
4. View the resource
The resources that have been searched successfully are shown in the “RIGOL
Online Resource” catalog, as shown in the figure below.
5. Communication test
Right click the resource name such as DG5352