User Manual

RIGOL Chapter 10 Advanced Operation

User‟s Guide for DG5000

10-22

Users could store the screen graph into external USB flash device or print it using

PictBridge printer. Press Utility  Print to open print setting interface.

1. To Print Screen to PictBridge Printer

Connect the PictBridge printer first. Use USB cable to connect the USB Device

interface of the generator to the USB Host interface of the printer (as shown in

the figure below).

Set the Device Type to “Printer” (refer to To Set USB Device Type) and press

Pict Bridge to enter the setting interface.

 Print: Prints the screen after 10 seconds you press the key.

 Copies: Specifies the required number of copies to be printed by using the

knob. The maximum is 9999 copies.

 Palette: Selects the picture color from “Gray” or “Color”.

 Inverted: Enables or disables the inverse print.

2. To Store Screen to USB Flash Device

Please connect a USB flash device first. When the connection succeeds, an

icon will be displayed on the status bar of the screen and the

corresponding prompt message will be displayed on the screen.

Press U Disk, a clock icon and a countdown prompt (10 s) will appear on the left

of the icon. Switching the screen to your desired image within the

specified time, the generator will automatically store the image under the folder

named “Rigol” (created automatically if it do not exist) in the USB flash device in

bitmap form (*.BMP). If the storage operation succeeds, the screen will display

corresponding prompt message.

DG5000

PictBridge Printer

USB Host USB Device

USB Cable