Instruction Manual

Chapter 11 Remote Control RIGOL
DG4000 Series User’s Guide
11-9
2. To Control the Instrument through LAN
1) Connect the devices
Connect the generator to your LAN using network cable.
2) Configure LAN parameters
Set the LAN parameters of the generator according to the introductions in
To Configure the Remote Interface.
3) Search device resource
Start-up Ultra Sigma and click
, then click in
the pop-up window, the software starts searching the generator
resources connected to LAN. Instrument resources searched will be
displayed in the right of the window. Select your desired resource and
click
, as shown in the following figures.
BNC Scientific, a division of Berkeley Nucleonics Corporation
2955 Kerner Blvd, San Rafael CA 94901 USA –www.bncscientific.com
Chat Online or email [e-mail]– Toll Free: 866-276-6188, Fax [phone]