Instruction Manual

Chapter 10 Utility and System Settings RIGOL
DG4000 Series User’s Guide
10-9
and 169.254.255.254 and subnet mask 255.255.0.0 automatically
according to the current network configuration.
z Press AutoIP to select “On” or “Off” to turn AutoIP mode on or off. To
enable this mode, set DHCP as “Off”.
3. ManualIP
z In ManualIP mode, the LAN parameters of the generator, e.g. IP address,
are defined by users.
z Press ManualIP to select “On” or “Off” to turn ManualIP mode on or off.
To enable this mode, set DHCP and AutoIP as “Off”.
z The IP address format is nnn.nnn.nnn.nnn. The first nnn ranges from 0 to
223 (except 127) and the other three nnn range from 0 to 255. It is
recommended that users acquire an available IP from their network
administrator.
z Press IP Address and use the numeric keyboard and direction keys to
enter your desired IP. The setting is stored in non-volatile memory and
will be loaded automatically when the generator is powered on the next
time if DHCP and AutoIP are set as “Off”.
Tips
z If all the three IP configuration modes are “On”
, the priority of
parameters configuration from high to low is “DHCP”, “AutoIP”
and
“ManualIP”.
z The three IP configuration modes cannot be set as “Off”
at the same
time.
To Set Subnet Mask
In ManualIP mode, the subnet mask could be manually set.
z The format of subnet mask is nnn.nnn.nnn.nnn, where nnn ranges from 0 to
255. It is recommended that users acquire an available subnet mask from
their network administrator.
z Press SubMask and use the numeric keyboard and direction keys to enter
your desired subnet mask. The setting is stored in non-volatile memory and
will be automatically loaded when the generator is powered on the next time if
DHCP and AutoIP are set as “Off”.
BNC Scientific, a division of Berkeley Nucleonics Corporation
2955 Kerner Blvd, San Rafael CA 94901 USA –www.bncscientific.com
Chat Online or email [e-mail]– Toll Free: 866-276-6188, Fax [phone]