Instruction Manual

Chapter 10 Utility and System Settings RIGOL
DG4000 Series User’s Guide
10-7
To Configure the Remote Interface
DG4000 is configured with USB and LAN interfaces and supports users to
configure the interface parameters for remote communication.
Press Utility Æ I/O Setup to open the I/O setting menu and set the LAN
interface parameters for remote communication or select the type of device
connected to the USB interface.
LAN Setting
Press Utility Æ I/O Setup Æ LAN to open the LAN parameters configuration
interface as shown in the following figure. Users can examine network status and
configure network parameters.
Figure 10-4 LAN Setting Interface
Network Status
Different prompt messages will be provided by the generator based on the current
network status.
z Connected: LAN connection is successful.
z Disconnect: LAN connection is unsuccessful.
Current IP Configure Mode
Network Status
IP Configure Mode status
MAC Address
VISA Descriptor
BNC Scientific, a division of Berkeley Nucleonics Corporation
2955 Kerner Blvd, San Rafael CA 94901 USA –www.bncscientific.com
Chat Online or email [e-mail]– Toll Free: 866-276-6188, Fax [phone]