Owner's manual

ManualsBrandsBNC ManualsGenerators845-M



19



Model 845-M Programmer’s

Manual

V1.1 2011

SCPI

Command Description

:ABORt

Subsystem

The

:ABORt command is

a

single command subsystem.

There are no

subcommands

or associated data

parameters, as

shown below. The

:ABORt

c

ommand,

along with the

:TRIGger

and :INITiate

commands,

comprise

the Trigger group of commands.

Command Parameters

Unit

(defa

u

lt)

Remar

k

:ABORt V0.3.10

:ABORt

:ABORt

This command causes

the

List

or Step sweep in

progress

to abort.

Even

if

INIT:CONT[:ALL] is

set to ON,

the sweep will not immediately

re-initiate.