Manual
30
Model 835-M Programmer’s
Manual
V1.1 2011
:LIST:DELay:AUTO
[SOURce]:LIST:DELay:AUTO
ON|
O
FF|1|
0
This command
enabled the
automati
c
blanking of the output during
transients
between
two
frequency
steps.
*RST
ON
:LIST:FREQency:POINts
[SOURce
]:LI
ST:POINt
s
?
This command queries
the
signal
generator for the number of
frequency
points in the current list
sweep
file.
:LIST:FREQuency
[SOURce]:LIST:FREQuency
<value>{,<value>}
[SOURce
]:LIS
T
:FRE
Quenc
y
?
This command sets
the frequency
values
for the
c
u
rrent
list sweep points. The
maximum number of list sweep points
is
3’501.
The variable <value>
is expressed
in units of
Hert
z.
The setting enabled by this
command is
not affected by
signal
generator power- on, preset, or
*RST.
Range Please consult
the Data Sheet.
:L
IST:MANual
[SOURce]:LIST:MANual
<value>|UP|DOWN
[SOURce]:LIST:MANual?
This command sets
a list or step sweep point
as
the current sweep point controlling
the
frequency
and power output. If list or step mode
is
controlling
frequency
or power, or
both,
then the indexed
point in the
respective list(s)
will be used.
Entering
a value with this
command
will have no effect,
unless
MANual
is
the
selected
mode. Refer
to
:LIST:MODE command
for setting the proper mode.
If the point
selected is
beyond the length of the longest enabled list, then the point will be set to the
maximum
possible
point, and an error will be generated.
Range
1–3’50
1
:LIST:MODE
[SOURce]:LIST:MODE
AUTO|MANual
[SOURce]:LIST:MODE?
This command sets
the operating mode for the current list or step sweep.
AUTO
This choice enables
the
selected
sweep type to perform a sweep of all points. MANual
This choice enables
you to
select
a
single
sweep point. The
selected
point
controls
the
frequency
and/or amplitude
according
to the sweep type. Refer
to
:LIST:MANual command
for
selecting
a sweep
point.
*RST
AUTO
:LIST:POWer
[SOURce]:LIST:POWer
<value>{,<value>}
[SOURce]:LIST:POWer?
This command sets
the amplitude for the current list sweep points.
:LIST:POWer:POINts
[SOURce]:LI
ST:POW
e
r:POINts
?
This command queries
the number of power points in the current list sweep
file.
:LIST:COUNt