Manual
29
Model 835-M Programmer’s
Manual
V1.1 2011
[SOURce]:LIST
Subsystem
Command Parameters
Unit
(defa
u
lt)
Remar
k
[SOURce]:LIST:DIRection UP|DOWN|RANDom
UP
V0.3.9
[SOURce]:LIST:DWELl <value>
s
V0.3.9
[SOURce]:LIST:DELay
<value>
s
V0.3.9
[SOURce]:LIST:DELay:AUTO ON|OFF|1|0
ON
V0.3.9
[SOURce
]:LIS
T
:FRE
Quenc
y
:POINts
?
V0.3.9
[SOURce
]:LIS
T
:FRE
Quenc
y
<value>{,<value>}
Hz
V0.3.9
[SOURce]:LIST:MANual <value>|UP|DOWN V0.3.9
[SOURce]:LIST:MODE AUTO
|
MANual
V0.3.9
[SOURce]:LIST:POWer <value>{,<value>}
dBm
V0.3.9
[SOURce]:LIST:POWer:POINts? V0.3.9
[SOURce]:LIST:COUNt <value>|INFinity
1
[SOURce]:LIST:PROGress? V0.3.9
:LIST:DIRection
[SOURce]:LIST:DIRection
UP|DOWN|RANDom
[SOURce]:LIST:DIRection?
This command sets
the
direction
of a list or step sweep.
UP This choice enables
a sweep in an
ascending
order:
•
first to last point for a list sweep
•
start to stop for a step sweep
DOWN
This choice reverses
the direction of the sweep.
*RST
UP
:LIST:DWELl
[SOURce]:LIST:DWELl
<value>{,<value>}
[SOURce]:LIST:DWELl:POINts?
This command sets
the dwell time for the current list sweep points. Dwell time
is used
when
IMMediate
is
the trigger
source.
The dwell time
is
the amount of time the sweep
is
guaranteed to
pause
after
setting the
frequency
and/or power for the current
point.
The setting enabled by this
command is
not affected by
signal
generator power- on, preset, or
*RST.
The variable <value>
is expressed
in units of seconds.
:LIST:DELay
[SOURce]:LIST:DELay
<value>{,<value>}
[SOURce]:LIST:DELay:POINts?
This command sets
the off time for the current list sweep points. Off time
is used
when
IMMediate
is
the trigger
source.
The off time
is
the amount of time the output
is
guaranteed
to
be blanked after
setting the
frequency
and/or power for the
c
u
rrent
point to
suppress
output
transients
during a
frequency
change.
The setting enabled by this
command is
not affected by
signal
generator power- on, preset, or
*RST.
The variable <value>
is expressed
in units of seconds.