Instruction Manual

Command List

The following table summarizes all the commands:

Sets the key click volume level.0 - 9VOLUME

Sets the character used as a decimal point on the display.0 = , (comma)

1 = . (period)

Fmark,

Enables/Disables the RS232 echo. The result string is

always sent back.

0 = Disable

1 = Enable

ECHO

Resets shot counter. SHOT ? will return the number of

shots.

0 = Reset to zeroSHOTS

Store a configuration.1 - 12STORE

Recall a stored configuration.0 - 12RECALL

Enable / disables the pulse generator output.0 = Disable

1 = Enable

RUN

Beeps the speaker inside the 507 the specified number of

times.

1 - 1000BEEP

Sets the delay, in microseconds*10, for Channel 20 - 999999998T2:Dly

Sets the pulse width, in microseconds*10, for Channel 21,000 - 1,000,000 T2:Wid

Sets the current level, in 10's of mA (100 = 1A), for

Channel 2

0 - 2500T2:Iamp

Enable/disable Channel 20 = Disable

1 = Enable

T2:Ena

Sets the delay, in microseconds*10, for Channel 1.0 - 999999998T1:Dly

Sets the pulse width, in microseconds*10, for Channel 1.1,000 - 1,000,000T1:Wid

Sets the current level, in 10's of mA (100 = 1A), for

Channel 1

0 - 2500T1:Iamp

Enable/disable Channel 10 = Disable

1 = Enable

T1:Ena

Sets the pulse generator mode.0 = Single Shot mode

1 = External Trigger mode

MODE

DescriptionParametersCommand

Name

507 Communication Commands