User guide

103
STORE option, you can select ON to instruct the meter to store the
measurement results for later retrieving or select OFF. Press ENTER to
set the value.
How to open and close the channels
Press CONFIG + SHIFT + FILTER for scanning configuration. Use ◁ and
▷ buttons to scroll through submenus. Press ENTER on “----” when you
need to close a specific channel. Press ENTER again on “CHANNEL”. Use
◁ and ▷ to move through the digits and △and ▽ to increase or
decrease the numbers to the desired channel number. Press ENTER to
close the channel. To open all channels, simply press ENTER on “OPEN
ALL” option. Press SHIFT + FILTER to scan as shown as Figure 4-32.
Figure 4-32
4.4.7 Initial Mode
The section contains two selections: “DEFAULT” and “SAVE DATA”. You
can select “SAVE DATE” to save the current configuration or select
“DEFAULT” to restore the factory value after restarting 1201. The valid
range of “SAVE DATA” is listed in Table 4-5.
No. Items of Save Data Contents
1 Continuity Threshold Resistance
2 Diode Boundary Voltage
3 Temperature (RTD) Sensor Types & Units
4 Thermocouple Types, Units, R Junction
5 Step & Scan Count, Timer
6 dBm Reference Resistance