Technical data
Table Of Contents
- E60 M5
- System overview
- Foreword
- Purpose of this Participant's Manual
- Introduction
- S85B50
- Basic engine and add-on parts
- Upper section of crankcase
- Bedplate
- Crankcase
- Cylinder head
- Crankshaft/main bearings
- Connecting rods
- Pistons
- Camshaft
- Valve springs
- Valve cotters
- Box-type tappets
- Valves
- VANOS High pressure pump
- VANOS Actuators
- VANOS gear mechanism
- VANOS Pressure accumulator
- Oil pumps
- Electric oil pumps
- Oil spray nozzles
- Oil filter housing
- Exhaust manifold
- Intake air manifold
- Intake silencers
- Radiator
- Thermostat
- Objectives
- Purpose of this Participant's Manual
- Introduction
- Functional Principle of the Digital Motor Electronics
- Digital Motor Electronics (DME)
- DME control unit Siemens MS_S65
- Hot-film air mass meter (HFM)
- Fuel pressure sensor
- Electric fuel pump (EKP)
- EKP module
- Ionic current control unit
- Crankshaft sensor
- Camshaft sensor
- Oil condition sensor (QLT)
- Oil pressure switch
- Oil extraction pump
- Idle speed actuator (LLS)
- Throttle valve actuator motor
- Throttle valve sensor (DKG)
- Secondary air pump
- Mini HFM for secondary air system
- Primary oxygen sensor (control sensor)
- Secondary oxygen sensor (monitor sensor)
- Exhaust gas temperature sensor
- Pressure accumulator shut-off valve (VANOS)
- Service information
- Objectives
- Purpose of this Participant's Manual
- New 7-speed SMG
- The new SMG3
- Special functions
- Transmission ratio of the SMG3
- Gearshift pattern
- Signals and parameters
- Hydraulic system
- Initialization
- Purpose of this Participant's Manual
- MK60E5 from Continental Teves
- Further development of the MK60psi
- DSC Additional Functions
- Differences compared to the MK60psi
- Purpose of this Participant's Manual
- Additional Functions
- Differences compared to the E60
- Displays and indicators in the E60 M5
20
8
Hydraulic system
A DC motor drives the hydrostatic pump. The
pump conveys the hydraulic oil via a non-
return valve into a pressure system while
energy is stored in a hydraulic accumulator.
The operating pressure is 75 bar. The
maximum pressure is 90 bar which is applied
only during initialization procedures.
The maximum shift force is approx. 2,500 N.
5 - SMG with hydraulic unit
Index Explanation
1 Hydraulic unit