Technical data
Table Of Contents
- E60 M5
- System overview
- Foreword
- Purpose of this Participant's Manual
- Introduction
- S85B50
- Basic engine and add-on parts
- Upper section of crankcase
- Bedplate
- Crankcase
- Cylinder head
- Crankshaft/main bearings
- Connecting rods
- Pistons
- Camshaft
- Valve springs
- Valve cotters
- Box-type tappets
- Valves
- VANOS High pressure pump
- VANOS Actuators
- VANOS gear mechanism
- VANOS Pressure accumulator
- Oil pumps
- Electric oil pumps
- Oil spray nozzles
- Oil filter housing
- Exhaust manifold
- Intake air manifold
- Intake silencers
- Radiator
- Thermostat
- Objectives
- Purpose of this Participant's Manual
- Introduction
- Functional Principle of the Digital Motor Electronics
- Digital Motor Electronics (DME)
- DME control unit Siemens MS_S65
- Hot-film air mass meter (HFM)
- Fuel pressure sensor
- Electric fuel pump (EKP)
- EKP module
- Ionic current control unit
- Crankshaft sensor
- Camshaft sensor
- Oil condition sensor (QLT)
- Oil pressure switch
- Oil extraction pump
- Idle speed actuator (LLS)
- Throttle valve actuator motor
- Throttle valve sensor (DKG)
- Secondary air pump
- Mini HFM for secondary air system
- Primary oxygen sensor (control sensor)
- Secondary oxygen sensor (monitor sensor)
- Exhaust gas temperature sensor
- Pressure accumulator shut-off valve (VANOS)
- Service information
- Objectives
- Purpose of this Participant's Manual
- New 7-speed SMG
- The new SMG3
- Special functions
- Transmission ratio of the SMG3
- Gearshift pattern
- Signals and parameters
- Hydraulic system
- Initialization
- Purpose of this Participant's Manual
- MK60E5 from Continental Teves
- Further development of the MK60psi
- DSC Additional Functions
- Differences compared to the MK60psi
- Purpose of this Participant's Manual
- Additional Functions
- Differences compared to the E60
- Displays and indicators in the E60 M5
18
8
Oil pressure switch
The signal from this switch is transferred to
the DME where it is evaluated. In the event of
a deviation from the specified value, the DME
sends a corresponding message to the CID
which in turn displays an associated check
control message.
Oil extraction pump
Two independent return pumps are installed
on the S85B50.
Different from the predecessor model, these
pumps are activated as from a centrifugal
force of 0.8 G.
The pumps extract the engine oil that remains
in the cylinder head and conveys it to the oil
sump.
The DSC informs the DME of the current
transverse force via the PT-CAN.
6 - Oil extraction pump