Technical data
Table Of Contents
- E60 M5
- System overview
- Foreword
- Purpose of this Participant's Manual
- Introduction
- S85B50
- Basic engine and add-on parts
- Upper section of crankcase
- Bedplate
- Crankcase
- Cylinder head
- Crankshaft/main bearings
- Connecting rods
- Pistons
- Camshaft
- Valve springs
- Valve cotters
- Box-type tappets
- Valves
- VANOS High pressure pump
- VANOS Actuators
- VANOS gear mechanism
- VANOS Pressure accumulator
- Oil pumps
- Electric oil pumps
- Oil spray nozzles
- Oil filter housing
- Exhaust manifold
- Intake air manifold
- Intake silencers
- Radiator
- Thermostat
- Objectives
- Purpose of this Participant's Manual
- Introduction
- Functional Principle of the Digital Motor Electronics
- Digital Motor Electronics (DME)
- DME control unit Siemens MS_S65
- Hot-film air mass meter (HFM)
- Fuel pressure sensor
- Electric fuel pump (EKP)
- EKP module
- Ionic current control unit
- Crankshaft sensor
- Camshaft sensor
- Oil condition sensor (QLT)
- Oil pressure switch
- Oil extraction pump
- Idle speed actuator (LLS)
- Throttle valve actuator motor
- Throttle valve sensor (DKG)
- Secondary air pump
- Mini HFM for secondary air system
- Primary oxygen sensor (control sensor)
- Secondary oxygen sensor (monitor sensor)
- Exhaust gas temperature sensor
- Pressure accumulator shut-off valve (VANOS)
- Service information
- Objectives
- Purpose of this Participant's Manual
- New 7-speed SMG
- The new SMG3
- Special functions
- Transmission ratio of the SMG3
- Gearshift pattern
- Signals and parameters
- Hydraulic system
- Initialization
- Purpose of this Participant's Manual
- MK60E5 from Continental Teves
- Further development of the MK60psi
- DSC Additional Functions
- Differences compared to the MK60psi
- Purpose of this Participant's Manual
- Additional Functions
- Differences compared to the E60
- Displays and indicators in the E60 M5
7
9
System components
Displays, Indicators and Controls
Displays and indicators in the E60 M5
Instrument cluster
The instrument cluster in the M5 is based on
that of the E60 Series. Corresponding
adaptations have been implemented in the
visual appearance and scope of functions for
use in the M5.
The additional functions are:
• Oil level indication in the on-board
computer
• Lighting at terminal 15 ON
• Oil temperature gauge in rev counter
• SMG display with Drivelogic display.
The M5 instrument cluster additionally
features the following indicator lamps:
• MDM for DSC dynamic mode
• M-Drive configuration is activated
• Light ON.
Head-up display (HUD)
The "M-view" has been added to the head-up
display. This expansion feature, however, is
implemented only in the software of the HUD
control unit.
The M-view can be configured in the "Display
Settings" menu in the i-Drive or with the
M-Drive and activated via the M-Drive
Manager.
The head-up display in the M-view can show
the following information:
• All warnings
• Engine speed with shift lights in the speed
indicator (not the absolute value)
• Road speed
• Engaged gear.
1 - Instrument cluster
2 - Head-up display in M-design